Finally, authentic side view! can safely drive in reverse to park, and navigate my station wagon and truck without tremendous acrobatics in the driver's seat. Simple to install.
I took a gamble on these because I needed them for my dana 300.... luckily they are the exact same dimensions. So if you need shift rail interlocks for a dana 300, these will fit.
They will look great on jeeps , shipping. was fast and item was as described I thought I left feed back , but I don't mind leaving it again and yes if I need something in future and you have it you" all hear from me....
Ordered three of these for my 42 Ford as I wanted to replace seals and the existing ones were to worn to be used again. Thought about using ready sleeves, but research showed these to be iffy and difficult to install so I went with new. The only disappointing thing about these yokes is that they do not come with the felt dust gasket. Jeepsterman does not carry them in their inventory. :-(
R
Randall Stewart
CJ2A front Pinion Yoke
It went on but,when I tightened the nut it almost locked the pinion shaft up,so pulled it back off to measure the depth with original,that seemed to be the same,put it back on but tightening the nut even the slightest woul create drag,cant figure it out,so I just ran it up with my fingers and had to turn it just a little to get cotter pin in,gonna leave it there right now until I figure out something,its got the engine,trans/transfer case out right now,my just fix my old one and put it back on!Not gonna rate it,until I figure out whats going on!
Choosing a selection results in a full page refresh.