New reproduction clutch cross shaft spring. 2 are required. These springs are located between the clutch release bellcrank and metal disc. These springs push the felt (A176) against the pivot studs. Fits:
High quality chrome settings and vintage look. Work well with my converted to 12 volt 51 Jeepster. Might use for turn signal addition to my original vehicle. May drill bumper splash pan but more likely will use bar mounts or fabricate from bumper bolts. These are otherwise hard to find vintage looking lights.
Perfect part…great quality. Only comment would be to remove the 49” if it’s out of stock or unavailable as it caused some confusion…but Jamie was super helpful and cleared it all up quickly!
Finally, authentic side view! can safely drive in reverse to park, and navigate my station wagon and truck without tremendous acrobatics in the driver's seat. Simple to install.
Got all of the suggested parts, installed , then no go. So, used old pressure plate with new parts , presto , shifts smoothly . Got some good technical advise from jeepster pros on this complex problem
Choosing a selection results in a full page refresh.