Quality of part is solid. Delivery was faster than expected. I used this part on a Jeepster with an automatic transmission. The parts were listed for a Jeepster with a manual, but photos and lengths matched my vehicle. Hard to know what parts and mods have been made to a 53 year old vehicle .
The unit bolted right on and lined up with the cable assembly side prefect and has just the right amount of windshield sweep. When the motor is turned off , the blades continue to the bottom of the windshield before motion stops. The motor , switch and wiring are top quality. .
The pieces are well made and fit well. That said, I was a bit disappointed that the metal wasn't straighter. I'm doing a show truck and had to do some work to make them look well. I'm Very happy to have found the scarce parts, thank you.
Ordered three of these for my 42 Ford as I wanted to replace seals and the existing ones were to worn to be used again. Thought about using ready sleeves, but research showed these to be iffy and difficult to install so I went with new. The only disappointing thing about these yokes is that they do not come with the felt dust gasket. Jeepsterman does not carry them in their inventory. :-(
R
Randall Stewart
CJ2A front Pinion Yoke
It went on but,when I tightened the nut it almost locked the pinion shaft up,so pulled it back off to measure the depth with original,that seemed to be the same,put it back on but tightening the nut even the slightest woul create drag,cant figure it out,so I just ran it up with my fingers and had to turn it just a little to get cotter pin in,gonna leave it there right now until I figure out something,its got the engine,trans/transfer case out right now,my just fix my old one and put it back on!Not gonna rate it,until I figure out whats going on!
Choosing a selection results in a full page refresh.