I did not get to use the point set I bought, but after installing them it indicated I needed a new distributor, which I bought from the Jeepster man. They will be setting in their box on a shelf in my garage until my children sell my estate. The new distributor wors great.
The 1952 M38 I bought had set up for a few years. The brake booster was a rusty sludge mess inside. I bought a new booster, flushed the lines, and replaced wheel cylinders. All new parts worked great and replaced the originals easily. I can now stop… huge plus.
the pan gasket for the 48 CJ2A was good quality, cleanly cut and fit as perfectly as one would expect. Except one small detail: It is only about half as thick as an old Victor! This was a small problem, easily remedied. You use a die grinder and cutoff wheel to cut off a bottom protrusion from the front plate which cuts into the gasket. This cut into the old Victor gasket and it held for a long time, but if you prune off that extra steel, the new gasket holds just as good. Use a little black Permatex RTV sealer at this three-sided joint.
J
Justin Simmons
Right parts. Good prices
Exactly what I needed. Thanks
Choosing a selection results in a full page refresh.