Wheel Cylinder, Rear, Left or Right, 1941-1953, Willys & Jeep, CJ2A, CJ3A, MB, and M38,

I took a gamble on these because I needed them for my dana 300.... luckily they are the exact same dimensions. So if you need shift rail interlocks for a dana 300, these will fit.

Good service

They will look great on jeeps , shipping. was fast and item was as described I thought I left feed back , but I don't mind leaving it again and yes if I need something in future and you have it you" all hear from me....

Fuel Tank, Poly, Driver Side, 1945-1964 Willys and Jeep, CJ-2A, CJ-3A, early CJ-3B

This is a much easier task with preformed lines. Fit great!

Muffler Assembly, 1946-1971, CJ-2A, CJ-3A, CJ-3B, CJ-5, Jeepster Commando

Quality of part is solid. Delivery was faster than expected. I used this part on a Jeepster with an automatic transmission. The parts were listed for a Jeepster with a manual, but photos and lengths matched my vehicle. Hard to know what parts and mods have been made to a 53 year old vehicle .

Valve Grind Gasket Set, 1941-1953, Willys and Jeep w/ 4-134 L-Head

Great service

This fit my 68 Jeepster Dana 30 rear axle perfectly. Make sure to take pictures before you disassemble so it goes together correctly.

Perfect fit axle seal behind the outer bearing.

The unit bolted right on and lined up with the cable assembly side prefect and has just the right amount of windshield sweep. When the motor is turned off , the blades continue to the bottom of the windshield before motion stops. The motor , switch and wiring are top quality. .

Fit perfect, Great service! & thank you for your help with my other items

Looks and works great

Quality reproduction hangers better than original.