JeepsterMan
Couldn't load pickup availability
These replacement floor panels are designed to extend from the rear floor riser forward to the toe board area and include an approximate 2" upward roll at the front edge. The outer edge is properly formed downward to attach to the side panel — just as original to the vehicle.
An additional 2" of material is provided at the transmission tunnel area, allowing flexibility during installation. This extra material can be rolled upward to accommodate variations or trimmed if not required.
For added authenticity, we have incorporated the original-style side panel drain hole well into our floor panels.
The passenger-side panel also correctly includes the toolbox floor section, maintaining proper factory configuration.
Installation Notes
If installing a military-style fuel tank, the installer will need to cut out the gas tank sump area on the driver-side floor panel. The driver-side floor support will also require modification for this application.
All appropriate mounting and accessory holes must be drilled by the installer as needed.
Additionally, these panels are manufactured approximately 2 inches wider than original specifications, providing extra material at the transmission hump area for proper hammer-forming if required. Excess material may be trimmed for a precise fit.
Be the first to ask a question about this.
